Fantasy Grounds Classic Connections Explained

[damned]

this is were im at after following the steps.

And does it work?

[Lazy]

no it still failed

[damned]

this is were im at after following the steps.

no it still failed

The steps conclude with:

Still need help?
Please dont post that you have "tried everything".
Please provide the following info when posting a request for Port Forwarding help.

1. Your LAN IP Address
2. The first two sets (octects) of your WAN IP as displayed by Fantasy Grounds and as displayed by your Router
3. Whether you are using Wired or Wireless (and not both)
4. Confirmation that you have set your Adapter in Network and Sharing Centre to Private
5. Confirmation of what AV you are running and whether you have set any exceptions
6. Post the results of the tracert 8.8.8.8 command (if you have security concerns you can remove this bit once its been responded to)
7. Confirmation as to what you have setup in your Router if changes have been made

[damned]

If you answer the 7 questions Im sure we can get to the bottom of your configuration.

[Lazy]

1. 192.168.1.50
2. Used Port Forwarding to look for internal (192.168.1.50) and external (99.38.116.205)
3. I'm wired
4. Network is set to Private.
5. AV and firewall dose have an exceptions for FG.
6. the tracert 8.8.8.8 command:
1 3 ms <1 ms <1 ms dsldevice.attlocal.net [192.168.1.254]
2 24 ms 29 ms 24 ms 76-230-56-1.lightspeed.livnmi.sbcglobal.net [76.230.56.1]
3 23 ms 23 ms 23 ms 71.151.244.93
4 24 ms 24 ms 24 ms 75.26.64.218
5 25 ms 30 ms 32 ms 12.83.32.181
6 31 ms 31 ms 31 ms gar26.cgcil.ip.att.net [12.122.99.93]
7 32 ms 31 ms 32 ms 12.247.108.6
8 * * * Request timed out.
9 32 ms 32 ms 32 ms 216.239.42.112
10 31 ms 32 ms 32 ms 72.14.237.31
11 31 ms 31 ms 33 ms google-public-dns-a.google.com [8.8.8.8]

7. Port 1802 has been made correctly in my router/modem.

Hopefully these was what you were asking for.

[damned]

If its still not working then most likely something there is stsill not setup correctly.
Please post a screenshot of: your port forward settings and delete the existing FG firewall rules and create a new one. Port, Incoming, TCP, 1802, always from anywhere.

[Lazy]

Screenshot 2019-03-19 16.24.40.png

Here the screenshot.

[damned]

Good stuff. So that screenshot shows that you have defined the FG port requirements/service. Now you need to create a NAT entry/rule that uses that service and applies it to your computers LAN IP.

[Lazy]

ok, I'm not too sure on how to do that but I'll google it.

[Lazy]

Screenshot 2019-03-19 19.25.57.png

Is this it?